SilverStone ST55GF Specifications Page 5

  • Download
  • Add to my manuals
  • Print
  • Page
    / 16
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 4
ST55GF
04
3.2 DC Voltage Regulation, Ripple and Noise
The power supply output voltages must stay within the following voltage limits when
operating at steady state and dynamic loading conditions. All outputs are measured with
reference to the return remote sense (ReturnS) signal. The +5V,+12V, -12V and +5BSB
outputs are measure at the power supply connectors references to ReturnS. The +5V and
+3.3V is measured at its remote sense signal (+5VS+, +3.3VS+) located at the signal
connector.
Table 7 - Regulation, ripple and noise
Ripple and noise shall be measured using the following methods:
a) Measurements made differentially to eliminate common-mode noise
b) Ground lead length of oscilloscope probe shall be 0.25 inch.
c) Measurements made where the cable connectors attach to the load.
d) Outputs bypassed at the point of measurement with a parallel combination of 10uF
tantalum capacitor in parallel with a 0.1uF ceramic capacitors.
e) Oscilloscope bandwidth of 0 Hz to 20MHz.
f) Measurements measured at locations where remote sense wires are connected.
g) Regulation tolerance shall include temperature change, warm up drift and dynamic load
3.3 Dynamic Loading
The output voltages shall remain within the limits specified in Table 7 for the step loading
and within the limits specified in Table 8 for the capacitive loading. The load transient
repetition rate shall be tested between 50Hz and 5kHz at duty cycle ranging from 10%-90%.
The load transient repetition rate is only a test specification. The
Δ
step load may occur
anywhere within the MIN load to the MAX load shown in Table 5 and Table 6.
Table 8 - Transient Load requirements
+5V +5VSB+12V -12V+3.3VOutput Voltage
+5%/-5% +5%/-5% +5%/-5% +5%/-5% +10%/-10% Load Reg.
±
1%
±
1%
±
1%
±
1%
±
1%
Line Reg.
Ripple & Noise 50mV 50mV 50mV120mV 120mV
Output
Δ
ep Load Size
Load Slew Rate
Capacitive Load
30% of Max.
Load 0.5 A/uS
Load 0.5 A/uS
Load 0.5 A/uS
Load 0.5 A/uS
30% of Max.
30% of Max.
30% of Max.
100uF
1000 uF
1000 uF
2200 uF
+5V
+3.3V
+12V
+5VSB
Page view 4
1 2 3 4 5 6 7 8 9 10 ... 15 16

Comments to this Manuals

No comments